Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Manual de usuario descargar pdf (Pagina 257)

P-793H User’s Guide

Chapter 23 WAN Setup 257

23.2 Configuring Traffic Redirect

From the main menu, in menu 2, select Yes in Traffic Redirect, and then press [ENTER].

Figure 139 Menu 2.1: Traffic Redirect Setup

The following table describes the fields in this menu.

23.3 Dial Backup Interface

In the SMT, to set up the auxiliary port for use, first make sure you have set up the switch and

port connection. Then, use the following menus.

1 Menu 2 - WAN Setup

2 Menu 2.2 - Dial Backup Setup

3 Menu 2.2.1 - Advanced Dial Backup Setup and

4 Menu 11.1 - Remote Node Profile (node 8, Backup ISP)

Menu 2.1 - Traffic Redirect Setup

Active= No

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 15

Table 94 Menu 2.1: Traffic Redirect Setup

FIELD DESCRIPTION

Active Use this field to turn the traffic redirect feature on (Yes) or off (No).

Configuration

Backup

Gateway IP

Address

Type the IP address of your backup gateway in dotted decimal notation. The ZyXEL

Device automatically forwards traffic to this IP address if the ZyXEL Device's Internet

connection terminates.

Metric This field sets this route's priority among the routes the ZyXEL Device uses.

The metric represents the "cost of transmission". A router determines the best route

for transmission by choosing a path with the lowest "cost". RIP routing uses hop count

as the measurement of cost, with a minimum of "1" for directly connected networks.

The number must be between "1" and "15"; a number greater than "15" means the link

is down. The smaller the number, the lower the "cost".

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to

save your configuration, or press [ESC] at any time to cancel.

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 431 432

Sin comentarios

Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Manual de usuario Pagina 257