Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Manual de usuario descargar pdf (Pagina 299)

100

101

P-793H User’s Guide

Chapter 30 Filter Configuration 299

CHAPTER 30

Filter Configuration

This chapter shows you how to create and apply filters.

30.1 Introduction to Filters

Your ZyXEL Device uses filters to decide whether to allow passage of a data packet and/or to

make a call. There are two types of filter applications: data filtering and call filtering. Filters

are subdivided into device and protocol filters, which are discussed later.

Data filtering screens the data to determine if the packet should be allowed to pass. Data filters

are divided into incoming and outgoing filters, depending on the direction of the packet

relative to a port. Data filtering can be applied on either the WAN side or the LAN side. Call

filtering is used to determine if a packet should be allowed to trigger a call. Remote node call

filtering is only applicable when using PPPoE encapsulation. Outgoing packets must undergo

data filtering before they encounter call filtering as shown in the following figure.

Figure 181 Outgoing Packet Filtering Process

For incoming packets, your ZyXEL Device applies data filters only. Packets are processed

depending upon whether a match is found. The following sections describe how to configure

filter sets.

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 431 432

Comentarios a estos manuales

Sin comentarios

Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H Manual de usuario Pagina 299

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Zyxel-communications G.SHDSL.bis 4-port Security Gateway P-793H