Zyxel-communications P-2802H(W)(L)-I Series Manual de usuario Pagina 241

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 418
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 240
Chapter 17 Quality of Service (QoS)
P-2802H(W)(L)-I Series User’s Guide
241
17.1.4 Automatical Priority Queue Assignment
If you enable QoS on the ZyXEL Device, the ZyXEL Device can automatically base on the
IEEE 802.1p priority level, IP precedence and/or packet length to assign priority to traffic
which does not match a class.
The following table shows you the internal layer-2 and layer-3 QoS mapping on the ZyXEL
Device. On the ZyXEL Device, traffic assigned to higher priority queues gets through faster
while traffic in lower index queues is dropped if the network is congested.
17.2 Configuring QoS General Screen
Click Advanced > QoS to open the screen as shown next.
Use this screen to enable or disable QoS, and select to have the ZyXEL Device automatically
assign priority to traffic according to the IEEE 802.1p priority level, IP precedence and/or
packet length. See Section 17.1 on page 239 for more information.
Table 99 Internal Layer2 and Layer3 QoS Mapping
PRIORITY
QUEUE
LAYER 2 LAYER 3
IEEE 802.1P USER
PRIORITY
(ETHERNET
PRIORITY)
TOS (IP
PRECEDENCE)
DSCP
IP PACKET
LENGTH (BYTE)
0 1 0 000000
12
2 0 0 000000 >1100
3 3 1 001110
001100
001010
001000
250~1100
44 2 010110
010100
010010
010000
5 5 3 011110
011100
011010
011000
<250
66 4 100110
100100
100010
100000
5 101110
101000
7 7 6 110000
111000
7
Vista de pagina 240
1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 417 418

Comentarios a estos manuales

Sin comentarios