ZyXEL Communications ZYWALL 5 - V4.04 Guía de usuario descargar pdf (Pagina 148)

ZyXEL Confidential

404XD3C0.docx

148/181

(4) It has the same problem when changing interface from "LAN" to "DMZ" if we do

the same action.

37. [BUG FIX]

Symptom: In bridge mode, SIP traffic cannot be managed by BWM.

Condition: SIP Phone1 ----- (LAN)ZyWALL(WAN) ------ SIP Phone2

(1) Change router to Bridge Mode.

(2) Enable BWM, and add a SIP filter at WAN interface.

(3) SIP Phone1 call SIP Phone2.

(4) After connection is established, go to eWC->BW MGMT->Monitor, you will see

SIP traffic falls into Default class, it's wrong.

38. [BUG FIX]

Symptom: Packet still can send out through NAT router when there is no unused port

for it.

Condition:

(1) Configure an active port forwarding rule with incoming port range 10000 to

29999.

(2) Send a packet out of NAT router.

(3) The packet can still send out.

39. [BUG FIX]

Symptom: BWM highest priority class cannot borrow residual bandwidth from parent

class (using tfgen tool)

Condition:

(1) In WAN interface. Enable Priority-based Scheduler.

(2) Class Setup on WAN.

Root 100000 Kbps

|-----WAN 2000 Kbps (No Borrow, No Filter, Priority = 3)

|-----WAN1-1 500 Kbps (Borrow; Filter: SrcIP:0, DestIP:0, SrcPort:0,

DestPort:90: Protocol: 17; Priority = 3 )

|-----WAN1-2 300 Kbps (Borrow, Filter: SrcIP:0, DestIP: 192.168.70.0/24,

SrcPort:0, DestPort:0, Protocol: 17; Priority= 6)

(3) From LAN host, use tfgen (UDP packet generator) to generate two session to

match class WAN1-1 and WAN1-2.

session 1: Utilization = 2000Kbps, Destination = WAN host (192.168.70.57),

port=90. This will match WAN1-1 class.

session 2: Utilization = 2000Kbps, Destination = WAN host(192.168.70.57), port

= default. This will match WAN1-2 class

(4) From Monitor, WAN1-1 should be protected at 500Kbps, and WAN1-2 should

borrow remaining bandwidth from parent class.

But you will see WAN1-1 still borrow remaining bandwidth and WAN1-2 almost

borrows nothing from parent class.

40. [BUG FIX]

Symptom: There is no response from DMZ after set system name by SNMP.

Condition:

(1) Reset to factory default setting.

(2) Disable firewall.

(3) Ping router's DMZ IP address continuity.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 180 181

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications ZYWALL 5 - V4.04 Guía de usuario Pagina 148

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications ZYWALL 5 - V4.04