Zyxel-communications NSA-2400 Manual de usuario descargar pdf (Pagina 3)

ENGLISH

1 Install Hard Drives

Note: Hard drives are NOT hot swappable. The NSA must be turned off before you

remove or install hard drive(s).

1 Pull the tab on the left of the front door of the NSA to open it.

2 Pull out the latch and

grip the sides of the

tray to remove disk tray

1. Be careful not to

break the latch. Disk

bay 1 is labelled on

your NSA (the top-left

bay).

3 Place the disk tray on a

flat surface with the

panel facing up. Place

a hard disk with the

screw holes facing up

on the same surface

and slide it into the disk

tray. Secure it with the

screws as shown.

4 Push the top of the tray

back into NSA disk bay

1 until it snaps into

place and push the

latch up as shown.

5 Repeat steps 1 to 3 for

other hard drives that

you may have.

2 Make the NSA Connections

1 Connect the Ethernet port on the rear of the NSA to a

hub, switch, or router on your network using an

Ethernet cable. Use an 8-wire Ethernet cable for

Gigabit connections.

1 2 3 4 5 6 7 8 ... 106 107

Sin comentarios

Zyxel-communications NSA-2400 Manual de usuario Pagina 3