Zyxel-communications U-336SA Manual de usuario descargar pdf (Pagina 56)

42 LCD Panel Operation

of the non-FSK modes the modem is supplied with. Before

synchronous transfers are started, some initial settings should be made.

V.25bis Command Set

To enable V.25bis commands use the AT*I1 command.

For synchronous applications, the modem is permanently set in normal

situations for use with one application. Save the desired settings in the

power-on profile, and the modem will be initialized to synchronous

mode (&M3) with V.25bis command enabled (*I1) when powered

on.

A special command RST is provided to get the modem back to

asynchronous AT command mode from V.25bis mode. You can enter

this RST command in either synchronous or asynchronous V.25bis

mode.

Syntax Command with

Parameters*

Description

CRN CRN

<dialstring>**

Call request with number provided.

CRS CRS n Call request with number from

memory, 0 # n # 49;

n is the memory location.

PRN PRN n;

Saves <number> to address n

(0 # n #49).

RLN RLN*** Requests list of all stored numbers.

DIC DIC Ignores incoming call.

CIC CIC Accepts incoming call.

CFI CFI XX Call failure indication:

ET Engaged Tone.

NS Number is not stored.

RING Tone.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 160 161

Sin comentarios

Zyxel-communications U-336SA Manual de usuario Pagina 56