Zyxel-communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Manual de usuario descargar pdf (Pagina 300)

Prestige 2602HW Series User’s Guide

300 Chapter 28 Remote Node Configuration

28.3.1 My WAN Addr Sample IP Addresses

The following figure uses sample IP addresses to help you understand the field of My WAN

Addr in menu 11.3. Refer to the previous Figure 18 on page 79 in the web configurator

chapter on LAN setup for a brief review of what a WAN IP is. My WAN Addr indicates the

local Prestige WAN IP (172.16.0.1 in the following figure) while Rem IP Addr indicates the

peer WAN IP (172.16.0.2 in the following figure).

Address

Mapping Set

When Full Feature is selected in the NAT field, configure address mapping sets in

menu 15.1. Select one of the NAT server sets (2-10) in menu 15.2 (see Chapter 31

on page 313 for details) and type that number here.

When SUA Only is selected in the NAT field, the SMT uses NAT server set 1 in menu

15.2 (see Chapter 31 on page 313 for details).

Metric The metric represents the cost of transmission for routing purposes. IP routing uses

hop count as the cost measurement, with a minimum of 1 for directly connected

networks. Type a number that approximates the cost for this link. The number need

not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good

number.

Private This determines if the Prestige will include the route to this remote node in its RIP

broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast.

If No, the route to this remote node will be propagated to other hosts through RIP

broadcasts.

RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction. Options are

Both, In Only, Out Only or None.

Version Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-1,

RIP-2B or RIP-2M.

Multicast IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and None disables

IGMP.

IP Policies You can apply up to four IP Policy sets (from 12) by typing in their numbers separated

by commas. Configure the filter sets in menu 25 first (see Chapter 40 on page 391)

and then apply them here.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm

or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

Table 100 Menu 11.3 Remote Node Network Layer Options (continued)

FIELD DESCRIPTION

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 518 519

Sin comentarios

Zyxel-communications ADSL VoIP IAD with 802.11g Wireless 2602HW Series Manual de usuario Pagina 300