Zyxel-communications P-870H-51a v2 Manual de usuario descargar pdf (Pagina 6)

Checking the LEDs (Lights)

Look at the LEDs (lights) on the top panel of the P-870H/HW-51a v2.

• The POWER light blinks during start-up and is green once the P-

870H/HW-51a v2 is ready.

• Each ETHERNET light turns on if the corresponding ETHERNET

port is properly connected. The lights blink when the P-870H/HW-

51a v2 is sending or receiving data through the corresponding

ETHERNET port.

• The DSL light stays on if a physical DSL connection exists and

blinks when transmitting data.

• The INTERNET light is green when Internet access is available.

• The WLAN/WPS light stays green when the wireless LAN is ready.

It blinks when the P-870HW-51a v2 is sending/receiving data

through the wireless LAN. The WLAN/WPS light is not available on

the P-870H-51a v2.

 If none of the LEDs (lights) are on, check your connections.

Make sure that you have the power adaptor connected to the

P-870H/HW-51a v2 and plugged in to an appropriate power

source. Make sure the power source is turned on. Turn the

P-870H/HW-51a v2 off, wait for a few seconds and turn it

back on. If the LEDs are still off, contact your local vendor.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Zyxel-communications P-870H-51a v2 Manual de usuario Pagina 6