ZyXEL Communications P-661HNU-Fx Guía de usuario descargar pdf (Pagina 17)

ENGLISH

2. ETHERNET: If you want a wired connection to the P-661HNU-Fx, use

an Ethernet cable to connect a computer to one of these ports for

initial configuration and/or Internet access.

3. USB 2.0: You only need to use this port if you are connecting a USB

storage device, USB printer or a 3G adapter to the

P-661HNU-Fx.

4. ANTENNAS: Attach the included antennas.

5. POWER: Use the power adaptor provided with your P-661HNU-Fx to

connect this socket to an appropriate power source.

6. Push the power button to the on position and look at the LEDs (lights)

on the top panel of the P-661HNU-Fx.

• The POWER light blinks during start-up and stays on once the

P-

661HNU-Fx is ready.

• The ETHERNET light turns on if the corresponding ETHERNET

port is properly connected. If you do not connect a computer

correctly to this port, the ETHERNET light will not turn on.

• The WLAN/WPS stays on when the wireless LAN is ready. The

light will not turn on if the Wireless Connection is not activated.

The ETHERNET and WLAN/WPS lights blink when the P-661HNU-Fx is

sending or receiving data. If the POWER light does not turn on during

start up, try turning the P-661HNU-Fx off, check the connections, wait a

few seconds and then turn it back on. If the problem persists, you may

have a hardware problem and you need to contact your vendor.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

ZyXEL Communications P-661HNU-Fx Guía de usuario Pagina 17