ZyXEL Communications NXC5200 - V2.20 Manual de usuario descargar pdf (Pagina 7)

7/21

www.zyxel.com

Symptom:

If the WTP use the IP is xxx.xxx.xxx.xxx , the rogue AP will can’t detect. For

Example:192.168.123.231

ITS#130702340

8. [BUGFIX]SPR: 1309241736

Symptom:

No default gateway if no ethernet cable connecting to AP.

ITS#130902209

9. [BUGFIX]SPR: 1310301896

Symptom:

When on the first hour has station connect with the AP and has traffic, after that, didn’t has any

user connect with the AP, but the Daily Report for the radio traffic also show has a traffic.

ITS#130803812

10. [BUGFIX]SPR: 131106334

Symptom:

SNMP v2c can’t be disabled permanently after reboot NWA560-N. my test steps:1. Uncheck

SNMP v2c box from Configuration ＞ System ＞ SNMP Configuration2. Check running

config and show snmp status in console and there has no SNMP v2c enable3. Reboot

NWA3560-N via GUI4. SNMP v2c box has been checked again on GUI and also in console 5.

Even I disabled SNMPv2c by using CLI ”no snmp-server version v2c” after reboot AP SNMP

v2c still was enabled again.

ITS#131001797

11. [BUGFIX]SPR: 1311261371

Symptom:

The customer wants to know the radio is disabled or not via SNMP. Customer was checking

SNMP OID “ZYXEL-ES-WIRELESS::wlanCurrentChannel”. This SNMP OID in customer

‘test and my test always has last configured channel even I disable radio on WEB GUI.

ITS#131003839

12. [BUGFIX]SPR: 140114659

Symptom:

two NWA3550-N couldn’t establish WDS-link if we set WDS on radio 1, and radio 2 service

STA(MBSSID)

13. [BUGFIX]SPR: 140114660

Symptom:

When add a radio profile use 5G band mode + Channel ”36 - indoor use only” will cause the

following config command not configured.

14. [BUGFIX]SPR: 140114664

Symptom:

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Sin comentarios

ZyXEL Communications NXC5200 - V2.20 Manual de usuario Pagina 7