ZyXEL Communications NetAtlas Workgroup Guía de usuario descargar pdf (Pagina 214)

Chapter 19 IP Configuration

NetAtlas Workgroup User’s Guide

214

Figure 157 IP Configuration: OSPF: New OSPF Setting

The following table describes the related labels in this screen.

19.8.5 Configuring a New OSPF Virtual Link

Follow the steps below to create a new OSPF virtual link.

1 In the Device Panel list, right-click on a device.

2 Click Configuration > IP Configuration > OSPF.

3 Click Add in the Virtual Link pane.

Table 119 IP Configuration: OSPF: New OSPF Setting

LABEL DESCRIPTION

Name Enter a descriptive name (up to 32 printable ASCII characters) for identification

purposes.

Area ID Enter a 32-bit ID (that uses the format of an IP address in dotted decimal notation) that

uniquely identifies an area.

A value of 0.0.0.0 indicates that this is a backbone (also known as Area 0). You can

create only one backbone area on the switch.

Authentication Select an authentication method (Simple or MD5) to activate authentication. Select

None to disable authentication.

Interface(s) and virtual interface(s) must use the same authentication method as the

associated area.

Stub Network Select this option to set the area as a stub area.

If you enter 0.0.0.0 in the Area ID field, the settings in the Stub Network fields are

ignored.

No Summary Select this option to set the switch to not send/receive LSAs.

Default Route

Cost

Specify a cost (between 0 and 16777214) used to add a default route into a stub area

for routes which are external to an OSPF domain. If you do not set a route cost, no

default route is added.

Add Click Add to apply the changes and close this screen.

Cancel Click Cancel to discard all changes and close this screen.

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 241 242

Sin comentarios

ZyXEL Communications NetAtlas Workgroup Guía de usuario Pagina 214