ZyXEL Communications ZyAIR Guía de usuario descargar pdf (Pagina 42)

ZyAIR B-3000 User’s Guide

41 Chapter 3 Introducing the Web Configurator

Note: The management session automatically times out when the time period set in

the Administrator Inactivity Timer field expires (default five minutes). Simply log back

into the ZyAIR if this happens to you.

3.2 Resetting the ZyAIR

If you forget your password or cannot access the web configurator, you will need to reload the

factory-default configuration file or use the RESET button on the side panel of the ZyAIR.

Uploading this configuration file replaces the current configuration file with the factory-

default configuration file. This means that you will lose all configurations that you had

previously. The password will be reset to 1234.

3.2.1 .Procedure To Use The Reset Button

Make sure the SYS LED is on (not blinking) before you begin this procedure.

1 Press the RESET button for ten seconds or until the SYS LED, LINK LED or BDG/

RPT LED turns red, and then release it. If the SYS LED begins to blink, the defaults have

been restored and the ZyAIR restarts. Otherwise, go to step 2.

2 Turn the ZyAIR off.

3 While pressing the RESET button, turn the ZyAIR on.

4 Continue to hold the RESET button. The SYS LED will begin to blink and flicker very

quickly after about 20 seconds. This indicates that the defaults have been restored and the

ZyAIR is now restarting.

5 Release the RESET button and wait for the ZyAIR to finish restarting.

3.2.2 Method of Restoring Factory-Defaults

You can erase the current configuration and restore factory defaults in three ways:

Use the RESET button on the side panel of the ZyAIR to upload the default configuration file

(hold this button in for about 10 seconds or until the SYS LED, LINK LED or BDG/RPT

LED turns red). Use this method for cases when the password or IP address of the ZyAIR is

not known.

Use the web configurator to restore defaults (refer to Chapter 10).

Transfer the configuration file to your ZyAIR using FTP. See later in the part on SMT

configuration for more information.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 220 221

Sin comentarios

ZyXEL Communications ZyAIR Guía de usuario Pagina 42