Zyxel-communications 5 Series Manual de usuario descargar pdf (Pagina 141)

100

101

ZyWALL 5/35/70 Series User’s Guide

Chapter 7 Bridge Screens 141

CHAPTER 7

Bridge Screens

This chapter describes how to configure bridge settings. This chapter is only applicable when

the ZyWALL is in bridge mode.

7.1 Bridge Loop

The ZyWALL can act as a bridge between a switch and a wired LAN or between two routers.

Be careful to avoid bridge loops when you enable bridging in the ZyWALL. Bridge loops

cause broadcast traffic to circle the network endlessly, resulting in possible throughput

degradation and disruption of communications. The following example shows the network

topology that can lead to this problem:

• If your ZyWALL (in bridge mode) is connected to a wired LAN while communicating

with another bridge or a switch that is also connected to the same wired LAN as shown

next.

Figure 58 Bridge Loop: Bridge Connected to Wired LAN

To prevent bridge loops, ensure that your ZyWALL is not set to bridge mode while connected

to two wired segments of the same LAN or you enable RSTP in the Bridge screen.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 834 835

Comentarios a estos manuales

Sin comentarios

Zyxel-communications 5 Series Manual de usuario Pagina 141

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Zyxel-communications 5 Series