Zyxel-communications 70 Series Manual de usuario descargar pdf (Pagina 494)

100

101

ZyWALL 5/35/70 Series User’s Guide

Chapter 31 Maintenance 494

31.10 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a

.bin extension, for example, "zywall.bin". The upload process uses HTTP (Hypertext Transfer

Protocol) and may take up to two minutes. After a successful upload, the system will reboot.

See

Section 47.5 on page 621 for upgrading firmware using FTP/TFTP commands.

Click MAINTENANCE, and then the F/W UPLOAD tab. Follow the instructions in this

screen to upload firmware to your ZyWALL.

Device Mode Setup

Router Select this radio button and click Apply to set the ZyWALL to router mode.

LAN Interface IP

Address

Enter the IP address of your ZyWALL’ s LAN port in dotted decimal notation.

192.168.1.1 is the factory default.

LAN Interface

Subnet Mask

Enter the IP subnet mask of the ZyWALL’s LAN port.

DHCP DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows

individual clients (computers) to obtain TCP/IP configuration at startup from a

server. Unless you are instructed by your ISP, leave the DHCP check box

selected. Clear it to stop the ZyWALL from acting as a DHCP server. When

configured as a server, the ZyWALL provides TCP/IP configuration for the clients.

If not, DHCP service is disabled and you must have another DHCP server on

your LAN, or else the computers must be manually configured. When set as a

server, fill in the rest of the DHCP setup fields.

IP Pool Starting

Address

This field specifies the first of the contiguous addresses in the IP address pool.

Pool Size This field specifies the size, or count of the IP address pool.

Bridge When the ZyWALL is in bridge mode, there is no need to select or clear this radio

button.

IP Address Click Bridge to go to the Bridge screen where you can view and/or change the

bridge settings.

Apply Click Apply to save your changes back to the ZyWALL. After you click Apply,

please wait for one minute and use the IP address you configured in the LAN

Interface IP Address field to access the ZyWALL again.

Reset Click Reset to begin configuring this screen afresh.

Table 178 Device Mode (Bridge Mode) (continued)

LABEL DESCRIPTION

1 2 ... 489 490 491 492 493 494 495 496 497 498 499 ... 806 807

Comentarios a estos manuales

Sin comentarios

Zyxel-communications 70 Series Manual de usuario Pagina 494

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Zyxel-communications 70 Series