Zyxel-communications P-335WT Manual de usuario descargar pdf (Pagina 313)

P-335 Series User’s Guide

Chapter 27 Remote Node Configuration 313

Figure 162

Menu 11.6 - Traffic Redirect Setup

Active= Yes

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 15

Check WAN IP Address= 0.0.0.0

Fail Tolerance= 2

Period(sec)= 5

Timeout(sec)= 3

Press ENTER to Confirm or ESC to Cancel:

Menu 11.6: Traffic Redirect Setup

The following table describes the fields in this screen.

Table 112 Menu 11.6: Traffic Redirect Setup

FIELD DESCRIPTION

Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic redirect

setup. The default is No.

Configuration:

Backup

Gateway IP

Address

Enter the IP address of your backup gateway in dotted decimal notation.

The Prestige automatically forwards traffic to this IP address if the Prestige’s Internet

connection terminates.

Metric Enter a number from 1 to 15 to set this route’s priority among the Prestige’s routes

(see the Metric section in the WAN and Dial Backup Setup chapter) The smaller the

number, the higher priority the route has.

Check WAN IP

Address

Enter the IP address of a reliable nearby computer (for example, your ISP’s DNS

server address) to test your Prestige’s WAN accessibility.

The Prestige uses the default gateway IP address if you do not enter an IP address

here.

If you are using PPTP or PPPoE Encapsulation, enter “0.0.0.0” to configure the

Prestige to check the PVC (Permanent Virtual Circuit) or PPTP tunnel.

Fail Tolerance Enter the number of times your Prestige may attempt and fail to connect to the

Internet before traffic is forwarded to the backup gateway. Two to five is usually a

good number.

Period (sec) Enter the time interval (in seconds) between WAN connection checks. Five to 60 is

usually a good number.

Timeout (sec) Enter the number of seconds the Prestige waits for a ping response from the IP

Address in the Check WAN IP Address field before it times out. The number in this

field should be less than the number in the Period field. Three to 50 is usually a good

number.

The WAN connection is considered “down” after the Prestige times out the number of

times specified in the Fail Tolerance field.

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or

[ESC] to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen

1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 508 509

Comentarios a estos manuales

Sin comentarios

Zyxel-communications P-335WT Manual de usuario Pagina 313

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Zyxel-communications P-335WT