ZyXEL Communications GS-3012 - VERSION 3.80 Guía de usuario descargar pdf (Pagina 229)

Chapter 28 Maintenance

GS-3012/GS-3012F User’s Guide

229

28.4 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It

also allows you to load configuration one (Config 1) or configuration two (Config 2) when

you reboot. Follow the steps below to reboot the Switch.

1 In the Maintenance screen, click the Config 1 button next to Reboot System to reboot

and load configuration one. The following screen displays.

Figure 132 Reboot System: Confirmation

2 Click OK again and then wait for the Switch to restart. This takes up to two minutes.

This does not affect the Switch’s configuration.

Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.

28.5 Firmware Upgrade

Make sure you have downloaded (and unzipped) the correct model firmware and version to

your computer before uploading to the device.

1 Be sure to upload the correct model firmware as uploading the wrong model

firmware may damage your device.

Click Management > Maintenance > Firmware Upgrade to view the screen as shown next.

Figure 133 Management > Maintenance > Firmware Upgrade

Type the path and file name of the firmware file you wish to upload to the Switch in the File

Path text box or click Browse to locate it. Select the Rebooting checkbox if you want to

reboot the Switch and apply the new firmware immediately. (Firmware upgrades are only

applied after a reboot). Click Upgrade to load the new firmware.

After the firmware upgrade process is complete, see the System Info screen to verify your

current firmware version number.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 313 314

Sin comentarios

ZyXEL Communications GS-3012 - VERSION 3.80 Guía de usuario Pagina 229