ZyXEL Communications GS-3012 - VERSION 3.80 Guía de usuario descargar pdf (Pagina 268)

Chapter 35 Configure Clone

GS-3012/GS-3012F User’s Guide

268

The following table describes the labels in this screen.

Table 108 Management > Configure Clone

LABEL DESCRIPTION

Source/

Destination

Port

Enter the source port under the Source label. This port’s attributes are copied.

Enter the destination port or ports under the Destination label. These are the ports

which are going to have the same attributes as the source port. You can enter

individual ports separated by a comma or a range of ports by using a dash.

Example:

• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.

• 2-6 indicates that ports 2 through 6 are the destination ports.

Basic Setting Select which port settings (you configured in the Basic Setting menus) should be

copied to the destination port(s).

Advanced

Application

Select which port settings (you configured in the Advanced Application menus)

should be copied to the destination ports.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the non-volatile memory when you are done

configuring.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 313 314

Sin comentarios

ZyXEL Communications GS-3012 - VERSION 3.80 Guía de usuario Pagina 268