ZyXEL Communications Version 1.03 Manual de usuario descargar pdf (Pagina 8)

Proprietary & Confidential Information

8. Fixed SPRID# 130402263: DUT often didn't return GUI after configured the DUT setting

9. Fixed SPRID# 130402268: Policy Forwarding can't work normally in QoS.

10. Fixed SPRID# 130402269: When QoS didn't set upstream and downstream bandwidth at

the same time. The QoS monitor can't work normally.

11. Fixed SPRID# 130403469: When WLAN disabled from GUI, it can't enable by HW

button.(Press 1~2 sec)

12. Fixed SPRID# 130410052: UPnP network connection can't work normally after

disconnected and connected WAN.( In this version not disconnected by UPnP)

13. Fixed SPRID#130410059: When removed the Vlan Group. The GUI still had group name

in LAN Setup and Additional Subnet.

14. Fixed SPRID# 130410060: The Ethernet WAN port can't light in Virtual Device.

15. Fixed SPRID# 130411152: DUT only can sent packets length1496 on PPPoA

WAN.(ZyXEL RD with PQA checked)

16. Fixed SPRID# 130411153: DUT PPPoE would connect down and up after used SuperGen

tool to send UDP packets.

17. Fixed SPRID# 130716282: Pre-configure General SSID via ROM file parameter. The

More AP SSID had changed, too.

18. Fixed SPRID# 130716285: MAC filter can't work on More AP.

19. Fixed SPRID# 130716331: VPN Monitor don't work.

20. Fixed SPRID# 130717359: The DUT console command can't work on SSH.

21. Fixed SPRID# 130718484: DUT had more PID didn't remove after DUT run a long time.

22. Fixed SPRID#130403462:The ping packets often request timeout.(Need in shading room

test)

23. Fixed SPRID# 130402270: Port Forwarding rule can't work when set asymmetric port

range.

24. Fixed SPRID# 130403467:DUT run multi-wan stress test overnight. DUT occurred

PPPoE and IPoE connection down and connection up.(If still has problem ,then please

help to capture packet or co-work with RD in MSTC test lab)

25. Fixed SPRID#130329549: ACL rule can't set ICMPv6 protocol.

26.

Modifications in 1.00(AAJZ.0)b5_D0 | 08/15/2013

[FEATURE ENHANCED]

1. Add a Qos Cli Command for Monitor. Command: qos

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Sin comentarios

ZyXEL Communications Version 1.03 Manual de usuario Pagina 8