ZyXEL Communications V300 Guía de usuario descargar pdf (Pagina 5)

V-300 Support Notes

All PCs must have an Ethernet adapter card installed.

• If you only have one PC, connect the PC's Ethernet adapter to the V300's PC port with a crossover (red

one) Ethernet cable.

2. TCP/IP Installation

You must first install TCP/IP software on each PC before you can use it for management V300. If you have

already installed TCP/IP, go to the next section to configure it; otherwise, follow these steps to install:

• In the Control Panel/Network window, click Add button.

• In the Select Network Component Type windows, select Protocol and click Add.

• In the Select Network Protocol windows, select Microsoft from the manufacturers, then select TCP/IP

from the Network Protocols and click OK.

3. TCP/IP Configuration

Follow these steps to configure Windows TCP/IP:

• In the Control Panel/Network window, click the TCP/IP entry to select it and click Properties button.

• In the TCP/IP Properties window, select Use the following IP Address and specify your PC one

arbitrary ip address/subnet mask as 192.168.5.2/255.255.255.0 to be the same ip segment of the

management ip.

Note: This arbitrary IP address and subnet mask in your PC is to management and configure the V300. After

you finishing the configuration, you are able to change back TCP/IP configuration to obtain ip address

automatically in your LAN to access internet.

• Click the WINS configuration tab and select Disable WINS Resolution.

• Click the Gateway tab. Highlight any installed gateways and click the Remove button until there are

none listed.

• Click the DNS Configuration tab and select Disable DNS.

• Click OK to save and close the TCP/IP properties window

• Click OK to close the Network window. You will be prompted to insert your Windows CD or disk.

• Setting up the V300 IP phone

1 2 3 4 5 6 7 8 9 10 ... 42 43

Sin comentarios

ZyXEL Communications V300 Guía de usuario Pagina 5