ZyXEL Communications G-102 - V1.0 Guía de usuario descargar pdf (Pagina 207)

Ethernet Switch CLI Reference Guide

207

CHAPTER 58

Static Multicast Commands

Use these commands to tell the Switch how to forward specific multicast frames to specific

port(s). You can also configure which to do with unknown multicast frames using the

router igmp unknown-multicast-frame command (see Table 58 on page 101).

58.1 Command Summary

The following section lists the commands for this feature.

Table 122 ip route Command Summary

COMMAND DESCRIPTION M P

show mac address-table multicast Displays the multicast MAC address table. E 3

multicast-forward name <name>

mac <mac-addr> vlan <vlan-id>

inactive

Creates a new static multicast forwarding rule. The rule name

can be up to 32 printable ASCII characters.

mac-addr: Enter a multicast MAC address which identifies

the multicast group. The last binary bit of the first octet pair in

a multicast MAC address must be 1. For example, the first

octet pair 00000001 is 01 and 00000011 is 03 in

hexadecimal, so 01:00:5e:00:00:0A and 03:00:5e:00:00:27

are valid multicast MAC addresses.

vlan-id: A VLAN identification number.

Note: Static multicast addresses do not age out.

C13

multicast-forward name <name>

mac <mac-addr> vlan <vlan-id>

interface port-channel <port-

list>

Associates a static multicast forwarding rule with specified

port(s) within a specified VLAN.

C13

no multicast-forward mac <mac-

addr> vlan <vlan-id>

Removes a specified static multicast rule. C 13

no multicast-forward mac <mac-

addr> vlan <vlan-id> inactive

Activates a specified static multicast rule. C 13

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 285 286

Sin comentarios

ZyXEL Communications G-102 - V1.0 Guía de usuario Pagina 207