ZyXEL Communications omni.net Guía de usuario Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 84
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
Omni.Net Lite User’s Guide
Chapter 3 Using AT Commands 56
No parity, 8 data bits, 1 stop bit, flow control set to hardware
6 The DTR LED is on. If it is off, check the HyperTerminal settings and your cable
connections.
7 Type in AT and press
[ENTER]. The terminal will response OK as shown below. You can
now use the commands with an “AT” or “at” prefix to configure the TA. Refer to Chapter
5 on page 72 for detailed information on AT command sets.
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 83 84

Comentarios a estos manuales

Sin comentarios