ZyXEL Communications omni.net Guía de usuario descargar pdf (Pagina 67)

Omni.Net Lite User’s Guide

Chapter 3 Using AT Commands 66

3.4.8.2 Voice Call

Use AT!pId=<phone number> [/<sub-address>] to configure a list of incoming

call phone numbers (with sub-addresses), then use AT!pP0=n to reject or accept the calls

with the phone number in the list.

3.4.9 Outgoing Call Screening

Use this function to set restrictions on outgoing calls, such as allowing or prohibiting a long-

distance or international call.

Refer to Section 3.4.9 on page 66 for more information.

3.4.9.1 Data Call

Use AT%Od=<prefix digits> to configure a list of prefix digits for outgoing calls, then

use AT%P1=n to prohibit or allow the calls with the prefix digits in the list.

3.4.9.2 Voice Call

Use AT!pOd=<prefix digits> to configure a list of prefix digits for outgoing calls,

then use AT!pP0=n to prohibit or allow the calls with the prefix digits in the list.

Figure 21 AT Command Example 3

3.4.10 Caller ID

Use AT!pA0=n to select the device type to enable call waiting caller ID when you have a call

(see Section 3.4.10 on page 66 for more information).

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 83 84

Sin comentarios

ZyXEL Communications omni.net Guía de usuario Pagina 67