ZyXEL Communications P-841 Guia de preparacion descargar pdf (Pagina 5)





 VDSL Hospitality 100 Rooms or Less Setup Guide

1/05/05 Page 5 of 21

Installation

Telephone closet preparation

One of the trickiest parts with setting up a VDSL network is integrating it with the existing telephone

service. Although the ISP will usually take care of installing the Internet connection where you need it,

they will not help you install it with your in-building DSL solution.

Typically the telephone company providing the building’s voice service will contract installers to set up

and maintain in-building voice equipment and PBXs. Therefore, you will probably need to contact your

telephone company to have the contractor help install the necessary connectors for your voice service, if

they are not already present.

The input and output for all ZyXEL DSL DSLAM equipment is a standard Telco-50 connector. These

connectors are trapezoidal in appearance and contain 50 pins, which are paired up to provide the

necessary pair to each user or room. The contractor will need to terminate all connections coming from

the PBX to Telco-50 connectors in order for them to be properly connected to your VES equipment. Also,

the connections going to each room will also need to be terminated with Telco-50 connectors.

Typically, all of the PBX and room lines will be connected to a Main Distribution Frame (MDF) inside of

the telco closet. The MDF usually consists of two parts: an upper block for the incoming lines, and a

lower block for outgoing lines to users. These may or may not already be terminated into Teclo-50

connectors. Your Teclo-50 connectors will most likely be installed into this MDF. When wiring these

Telco-50 connectors, it is important that they be wired for the correct pin-outs, as explained below.

Proper Pin-Outs

The pin-outs for the Telco-50 connectors will depend on the VES equipment being used. Here is an

example pin-out from the VES-1124 DSLAM:

Pin-outs are located in the Appendix section of your unit’s User’s Guide. Please be sure to have the

contractor refer to these when installing your Telco-50 connectors; otherwise, your VES installation will

not work properly.

For more information on with connectors apply to the PBX and to room connections, please read the next

section.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Sin comentarios

ZyXEL Communications P-841 Guia de preparacion Pagina 5