Zyxel-communications IES-612-51A Manual de usuario Pagina 331

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 444
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 330
IES-612-51A User’s Guide
331
CHAPTER 49
IP Commands
This chapter shows you how to use the (standard shell) IP commands to configure the IP
(Internet Protocol) parameters.
49.1 IP Commands Introduction
Use the IES-612-51A’s management IP addresses to manage it through the network.
49.2 IP Settings and Default Gateway
Use the following command sequence to set the IES-612-51A’s IP settings for the Ethernet 1
and 2, and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports,
you must connect to the IES-612-51A through a port that is a member of the management
(CPU) VLAN in order to perform in-band management.
where
The first command changes the IP settings for the IES-612-51A’s uplink, downlink and IES-
612-51A DSL ports. If you don’t enter the subnet mask, the system automatically computes
the subnet mask.
Figure 194 IP Settings and Default Gateway Address Commands
ras> ip set <new ip address> [</netmask>]
ras> ip gateway <ip>
ras> config save
<new ip
address>
=
The IP address you want to configure for the IES-612-51A.
</netmask> =
The bit number of the subnet mask of the IP address you
want to configure for IES-612-51A’s uplink, downlink and
IES-612-51A DSL ports. To find the bit number, convert the
subnet mask to binary and add all of the 1’s together. Take
“255.255.255.0” for example. 255 converts to eight 1’s in
binary. There are three 255’s, so add three eights together
and you get the bit number (24).
<ip> =
The default gateway IP address you want to configure for
the IES-612-51A.
Vista de pagina 330
1 2 ... 326 327 328 329 330 331 332 333 334 335 336 ... 443 444

Comentarios a estos manuales

Sin comentarios