press ENTER again to save the entry in the EEPROM. The stored
numbers will remain in memory until you revise or delete them.
Pressing the up arrow key in the process will abort and exit the
current number entry and nothing will be changed or saved.
DIAL NUMBER
The same procedure is used when entering numbers, as in the STORE
NUMBER operation. After number entry is completed, press the
ENTER key to dial the number.
((MODE-12))
Equivalent AT command:
ATD1234567 Dial phone number.
MANUAL DIAL AND DATA/VOICE SWITCHING
Use of a telephone set to make a call, in which an answer tone
comes back, is normally called Manual Dial. Once the other side
answers, access the `O' (Originate) by using the left or right
arrow key so the blinking cursor settles on the `O'. Then press
the ENTER key to start the modem handshaking sequence.
Equivalent AT command:
ATD Originate on-line.
When dialing a person, use the telephone to make the call. When
someone on the other side answers, decide who will be the
Originate modem and who will be the Answer modem. Once an
agreement is reached, use the left or right arrow key to select
the `O' or `A' for Originate and Answer. Then press the ENTER key
to start the modem handshaking sequence.
Equivalent AT commands:
ATD Originate on-line.
ATA Answer on-line.
When you want to switch from modem to voice, simply lift up the
handsets of both sides and press the ENTER key while the blinking
cursor is on the `H' or Hang Up. The LCD display will show
"DISCONNECTING ?" to ask for a confirmation. Press ENTER again
and the modem will change from data to voice communication. When
both sides wish to return to data communication, one side should
press `O' while the other side presses `A' (as explained
previously). This operation will reinitiate the modem handshaking
and enable data communications.
For U-1496E, use the VOICE/DATA toggle switch for data/voice
switching and use the ANS/ORG switch to select originate mode or
Comentarios a estos manuales