(6) =1; Disable "RINGING" result code. (See ATXn).
(5) =1; button.
(4) =1; V.17 fax in calling mode, no effect on answering mode (See
&N0 and &N32).
(3) =1; Disable escape sequence code in answer mode.
(2) =1; CND message will be forced on even if ATQ2 is set. (See
S40b1).
(1) =1; Enable throughput averaging.
(0) =0; secondary channel, 75-2400 bps
=1; Select 2400 bps secondary channel.
Note: Secondary channel is available only on network management capable models, i.e., U-
1496RN and U-1496SN.
S43 Bit mapped register, default = 000
(7,6,5,4,) Reserved
(3) =1; Disable cellular mode.
(2) =1; Disable cellular mode Auto Transmit Power Adjustment. Use
S49b0-3 to set transmit power.
(1) =1; Disable ZyXEL 19200 bps in Multi-Auto mode.
(0) =1; Disable ZyXEL 16800 bps in Multi-Auto mode.
S44 Bit-mapped register, default = 000,
(6) =1; When selected with &B0, DTE speed fixed at 19200 when the link speed
is above 9600; at 9600 if link speed is 7200 and at link speed if it is below 7200. When selected
with &B1, DTE speed fixed at current rate when an ARQ connection is made; when a non-ARQ
connection is made; DTE speed follows link rate.
(5) =1; Enable V.13 half-duplex simulation in synchronous mode.
(4) =1; DSR follows DTR (See also S41b5).
(3) =1; Enable cyclic dial with ATDSn.
(2) =1; Semi-auto dial back-up, modem will wait for user's confirmation from
front panel before dialing to back up.
S45 Delay during which the CND silence detection is disabled. Unit is 20ms; default 087.
(See also S46).
S46 Silence detection. To process the CND signal, silence must be detected for the specified
amount of time. Unit is 20 ms; default = 003.
S47 CND attenuation. Attenuation while processing the CND signal. 1 is the highest
attenuation.
S48 Bit-mapped register, default=000
(0) =1; Causes CND information to be reported in raw data format.
S49 Bit-mapped register, default = 000
(7) =0; For cellular mode only, modem is installed in office.
=1; For cellular mode only, modem is in mobile use.
(6,5,4) Reserved.
(3,2,1,0) =0-15; Set cellular mode transmit power -9 to -24 dBm. (See also
S43b2.)
S50 Inactivity timer in 10-second units. Counts when there is no data flow in or out of the RS-
232 serial port.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales