ZyXEL Communications 650 Series Guía de usuario descargar pdf (Pagina 4)

Prestige 650H/HW

Table 1 Prestige Rear Panel Description

LABEL DESCRIPTION

1. DSL Connect to a telephone jack using the included phone wire.

2. LAN

1..4

Connect to a computer/external hub using an Ethernet cable.

3. POWER Connect to a power source using the power adapter for your region (see your User’s Guide).

After you’ve made the connections, connect the power cable to a power supply and push in the power button to

turn on the Prestige.

The PWR LED turns on. The SYS LED blinks while performing system testing and then turns steady on if the

testing is successful. A LAN LED turns on if a LAN port is properly connected.

CONSOLE Connect to a serial port (COM port) on your computer using the RS-232 end (the big end) of the

console cable (optional part). Connect the other end to the Prestige CONSOLE port.

RESET You only need to use this button if you’ve forgotten the Prestige’s password. It returns the

Prestige to the factory defaults (password is 1234, LAN IP address 192.168.1.1 etc.; see your

User’s Guide for details).

2.2 Inserting a PCMCIA Wireless LAN Card

To add optional wireless LAN capabilities, you need a ZyAIR series wireless LAN PCMCIA card.

Step 1. Locate the slot labeled Wireless LAN on the Prestige.

Step 2. With its pin connector facing the slot and the LED side facing upwards, slide the ZyAIR

wireless LAN card into the slot.

Never force, bend or twist the wireless LAN card into the slot.

Step 3. Restart the Prestige. The WLAN LED should turn on.

2.3 The Front Panel LEDs

Figure 2 Prestige Front Panel

1 2 3 4 5 6 7 8 9 ... 22 23

Sin comentarios

ZyXEL Communications 650 Series Guía de usuario Pagina 4