ZyXEL Communications P-2602HWL-D3A Manual de usuario descargar pdf (Pagina 17)

ZyXEL Confidential

340ajk4c0

17/35

edit forwardip [ip] set nat server server ip

edit protocol [protocol id] set nat server protocol

service

irc [on|off] turn on/off irc flag

resetport reset all nat server table entries

incikeport [on|off] turn on/off increase ike port flag

IPSec Related Command Home

Command Description

ipsec

debug <1|0> turn on|off trace for IPsec debug information

route lan <on|off> After a packet is IPSec processed and will be sent

to LAN side, this switch is to control if this

packet can be applied IPSec again.

Remark: Command available since 3.50(WA.3)

wan <on|off> After a packet is IPSec processed and will be sent

to WAN side, this switch is to control if this

packet can be applied IPSec again.

Remark: Command available since 3.50(WA.3)

show_runtime sa display runtime phase 1 and phase 2 SA

information

spd When a dynamic rule accepts a request and a

tunnel is established, a runtime SPD is created

according to peer local IP address. This

command is to show these runtime SPD.

switch <on|off> As long as there exists one active IPSec rule, all

packets will run into IPSec process to check SPD.

This switch is to control if a packet should do

this. If it is turned on, even there exists active

IPSec rules, packets will not run IPSec process.

timer chk_my_ip <1~3600> - Adjust timer to check if WAN IP in menu is

changed

- Interval is in seconds

- Default is 10 seconds

- 0 is not a valid value

chk_conn. <0~255> - Adjust auto-timer to check if any IPsec

connection has no traffic for certain period. If

yes, system will disconnect it.

- Interval is in minutes

- Default is 2 minuets

- 0 means never timeout

update_peer <0~255> - Adjust auto-timer to update IPSec rules which

use domain name as the secure gateway IP.

- Interval is in minutes

- Default is 30 minutes

- 0 means never update

Remark: Command available since 3.50(WA.3)

updatePeerIp Force system to update IPSec rules which use

domain name as the secure gateway IP right

away.

Remark: Command available since 3.50(WA.3)

dial <rule #> Initiate IPSec rule <#> from ZyWALL box

Remark: Command available since 3.50(WA.3)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications P-2602HWL-D3A Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications P-2602HWL-D3A