ZyXEL Communications P-2602R-63 Guía de usuario descargar pdf (Pagina 155)

Prestige 2602R Series User’s Guide

155 Chapter 20 Menu 2 WAN Backup Setup

20.2.1 Traffic Redirect Setup

Configure parameters that determine when the Prestige will forward WAN traffic to the

backup gateway using Menu 2.1 — Traffic Redirect Setup.

Figure 78

Menu 2.1 - Traffic Redirect Setup

Active= No

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 15

Press ENTER to Confirm or ESC to Cancel:

Menu 2.1Traffic Redirect Setup

The following table describes the fields in this menu.

Table 42 Menu 2.1Traffic Redirect Setup

FIELD DESCRIPTION

Active. Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic redirect

setup. The default is No

Configuration

Backup Gateway

IP Address

Enter the IP address of your backup gateway in dotted decimal notation.

The Prestige automatically forwards traffic to this IP address if the Prestige’s

Internet connection terminates.

Metric This field sets this route's priority among the routes the Prestige uses.

The metric represents the "cost of transmission". A router determines the best route

for transmission by choosing a path with the lowest "cost". RIP routing uses hop

count as the measurement of cost, with a minimum of "1" for directly connected

networks. The number must be between "1" and "15"; a number greater than "15"

means the link is down. The smaller the number, the lower the "cost"

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm

or ESC to Cancel:

” to save your configuration, or press [ESC] at any time to cancel.

Recovery Interval(sec) When the Prestige is using a lower priority connection (usually a WAN backup

connection), it periodically checks to whether or not it can use a higher priority

connection.

Type the number of seconds (30 recommended) for the Prestige to wait

between checks. Allow more time if your destination IP address handles lots of

traffic.

ICMP Timeout Type the number of seconds for an ICMP session to wait for the ICMP

response

Traffic Redirect Press [SPACE BAR] to select Yes or No.

Select Yes and press [ENTER] to configure Menu 2.1 Traffic Redirect Setup.

Select No (default) if you do not want to configure this feature.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm

or ESC to Cancel:

” to save your configuration, or press [ESC] at any time to cancel.

Table 41 Menu 2 WAN Backup Setup (continued)

FIELD DESCRIPTION

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 348 349

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications P-2602R-63 Guía de usuario Pagina 155

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications P-2602R-63