ZyXEL Communications P-2602R-63 Guía de usuario descargar pdf (Pagina 267)

Prestige 2602R Series User’s Guide

267 Chapter 35 Troubleshooting

35.3 Problems with the WAN

Table 80 Troubleshooting the WAN

PROBLEM CORRECTIVE ACTION

The DSL LED is

off.

Check the telephone wire and connections between the Prestige DSL port and the

wall jack.

Make sure that the telephone company has checked your phone line and set it up

for DSL service.

Reset your ADSL line to reinitialize your link to the DSLAM.

I cannot get a

WAN IP address

from the ISP.

The ISP provides the WAN IP address after authenticating you. Authentication

may be through the user name and password, the MAC address or the host name.

The username and password apply to PPPoE and PPPoA encapsulation only.

Make sure that you have entered the correct Service Type, User Name and

Password (be sure to use the correct casing). Refer to the WAN Setup chapter

(web configurator or SMT).

I cannot access

the Internet.

Make sure the Prestige is turned on and connected to the network.

Verify your WAN settings. Refer to the chapter on WAN setup (web configurator)

or the section on Internet Access (SMT).

Make sure you entered the correct user name and password.

If you use PPPoE pass through, make sure that bridge mode is turned on. See

Chapter 5 on page 60 or Chapter 19 on page 150 chapter for details.

The Internet

connection

disconnects.

Check the schedule rules. Refer to Chapter 34 on page 262 (SMT).

If you use PPPoA or PPPoE encapsulation, check the idle time-out setting. Refer

to the WAN Setup chapter (web configurator) or

Chapter 23 on page 166 (SMT).

Contact your ISP.

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 348 349

Sin comentarios

ZyXEL Communications P-2602R-63 Guía de usuario Pagina 267