
Vantage RADIUS Server User’s Guide
5-16 RADIUS Configuration
Step 5. Click OK to complete the installation.
5.9 Setting Up Your Access Point (AP)
This section assumes knowledge of how to configure a management session on your AP. The following
examples use screenshots from ZyXEL’s ZyAIR G-3000. Actual screens and products differ from the ones
displayed. Please consult your AP’s User’s Guide before making the changes below.
To avoid premature errors, make sure you first configure your access point
before configuring authentication settings and wireless clients.
5.9.1 ZyAIR G-3000 RADIUS Setup Example
The following example describes how to configure your AP’s RADIUS server settings for use with Vantage
RADIUS.
To set up your ZyAIR’s RADIUS server settings, click the WIRELESS link under ADVANCED and then
the RADIUS tab. The screen appears as shown.
Step 1. Make sure your RADIUS servers are activated.
Step 2. Type the IP address of your Vantage RADIUS in the Server IP Address field.
Step 3. Type the port numbers of the external authentication and accounting servers. The default port
numbers are 1812 and 1813 respectively. Make sure ZyAIR and Vantage RADIUS use the same
port numbers.
Step 4. Type a password (up to 31 alphanumeric characters) as the key to be shared between the
external authentication server and the wireless AP. The key must be the same on the external
authentication server and your wireless AP. The key is not sent over the network.
Comentarios a estos manuales