Zyxel-communications Internet Security Gateway ZyWALL 2 Series Manual de usuario descargar pdf (Pagina 479)

100

101

ZyWALL 2 User’s Guide

Firmware and Configuration File Maintenance 33-9

Step 1. Launch the FTP client on your computer.

Step 2. Enter “open”, followed by a space and the IP address of your ZyWALL.

Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is “1234”).

Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Find the “rom” file (on your computer) that you want to restore to your ZyWALL.

Step 7. Use “put” to transfer files from the ZyWALL to the computer, for example, “put config.rom

rom-0” transfers the configuration file “config.rom” on your computer to the ZyWALL. See

earlier in this chapter for more information on filename conventions.

Step 8. Enter “quit” to exit the ftp prompt. The ZyWALL will automatically restart after a successful

restore process.

33.4.2 Restore Using FTP Session Example

Figure 33-8 Restore Using FTP Session Example

Refer to section 33.3.5 to read about configurations that disallow TFTP and FTP over WAN.

33.4.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures

using other serial communications programs should be similar.

ftp> put config.rom rom-0

200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.

ftp>quit

1 2 ... 474 475 476 477 478 479 480 481 482 483 484 ... 613 614

Comentarios a estos manuales

Sin comentarios

Zyxel-communications Internet Security Gateway ZyWALL 2 Series Manual de usuario Pagina 479

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Zyxel-communications Internet Security Gateway ZyWALL 2 Series