Zyxel-communications Omni 56K II Manual de usuario descargar pdf (Pagina 66)

Omni 56K II and Omni 56K Plus II User’s Guide

5-20 Command Sets

COMMAND DESCRIPTION VALUE

+FNR=rpr,tpr,idr,nsr Enable Negotiation Reporting rpr= 0:Receiver parameters are

not reported.

rpr=1:Receiver parameters are

reported.

tpr= 0:Transmitter parameters

are not reported.

tpr=1:Transmitter parameters

are reported.

idr= 0: ID Strings are not

reported.

idr=1: ID Strings are reported.

nsr= 0:Non-standard frames

are not reported.

nsr= 1:Non-standard frames

are reported.

+FIE=n Procedure Interrupt parameter n=0:Disable

n=1:Enable

+FPS=n Page Transfer Status n=1:Received page is good.

n=2:Page is bad; retrain is

requested.

n=3:Page is good; retrain is

requested.

n=4:Page is bad; procedure

interrupt is requested.

n=5:Page is good; procedure

interrupt is requested.

+FLO=n Flow Control Select n=0:No flow control

n=1:Sets XON/ XOFF software

flow control

n=2:Sets CTS/RTS hardware

flow control

+FPR=n Serial Port Rate Control n=0:Automatic DTE rate

detection by the DCE

n>0:Serial rate is fixed at the

value multiplied by 2400 bps.

+FBO=n Phase C Data Bit Order n=0:Selects direct bit order

n=1:Selects reversed bit order

+FEA=n Phase C Received EOL alignment n=0:EOL patterns are as

received

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 87 88

Sin comentarios

Zyxel-communications Omni 56K II Manual de usuario Pagina 66