Zyxel-communications Omni 56K II Manual de usuario descargar pdf (Pagina 71)

Omni 56K II and Omni 56K Plus II User’s Guide

Command Sets 5-25

RESPONSE CODE DESCRIPTION

<DLE>u Transmission Buffer Underrun. The DCE reports this code if the DEC’s buffer

becomes empty without first receiving a <DLE><ETX> command.

<DLE><ETX> End of stream

5.6 S-Register Descriptions

In most bit-mapped S-registers, the default bit value is 0. An asterisk follows non-0 default values. In some

cases, default values are shown in the reference column preceded by +. Some bits are reserved for factory use

and should not be changed.

5.6.1 Basic S-Registers "ATSn=x"

Table 5-15 Basic S-Registers "ATSn=x"

COMMAND FUNCTION & DESCRIPTION REF.

S0= Sets the number of rings on which the modem will answer. A value of 0 disables

auto-answering.

+000

S1= Counts and stores the number of rings from an incoming call. +000

S2= Defines the escape code character, default ' +' (43 dec.). A value of 128-255 disables

the escape code.

+043

S3= Defines the ASCII Carriage Return. +013

S4= Defines the ASCII Line Feed. +010

S5= Defines the ASCII Backspace key. A value of 128-255 disables the Backspace key' s

delete function.

+008

S6= Sets the number of seconds the modem waits before dialing if ' X0' or ' X1' is

selected. If a setting of ' X2,' 'X7' is selected; the modem will dial as soon as it detects

a dial tone. This register also sets the time-out interval for the "W" dial modifier to

wait for the dial tone. (See also S41b4)

+003

S7= Sets duration, in number of seconds modem waits for a carrier. +060

S8= Sets duration, in seconds, for pause (,) option in Dial command and pause between

command re-executions for Repeat (>) command.

+002

S9= Sets duration, in tenths of a second of remote carrier signal before recognition.

(Ignored if in non-FSK or half-duplex operation)

+006

S10= Sets duration, in tenths of a second, that the modem waits after the carrier is lost

before hanging up.

+007

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 87 88

Sin comentarios

Zyxel-communications Omni 56K II Manual de usuario Pagina 71