ZyXEL Communications Omni 288S Manual de usuario descargar pdf (Pagina 24)

novaPro32 Routel

novaPro32 set-up

7000991003 Q2

Sauter Systems

novaNet PC

- This is the PC address. It has to be set identical to the one in the Routel. Refer to

Chapter 3.2.

Phone Number

- The phone number of the Routel island concerned.

Refer to your modem manual for special commands (e.g. ‘,’ makes the modem wait

for 1 or 2 seconds, ‘w’ makes the modem wait for the dial tone before continuing).

Remote Supervision Mode (Routel)

- Tick needs to be set to enable the Routel mode.

Message AS and ASNet Supervision

- If set, the Routel supervises the number of AS communicating on novaNet as well

as the presence of the AS net itself. If there is any change, the Routel will call the

Supervision PC.

Æ novaPro32 will make use of this message only from Version 4.1.

Message after Power Failure novaNet291

- Causes the Routel to call the Supervision PC after a return of the Supply Power to

the Routel.

- The received "Supply Supervision Messages" are logged into the Routel logfile.

Message and Refresh after 3

Party PC-Access

- If ticked, the Routel will report to the Supervision PC any access from a Remote

Access PC (mode Router) to the Routel. This, on one hand for security reasons, but

also because alarms occurring during the access of the Remote PC would be lost

on the Supervision PC (Routel memory flushed by the data reading from the

Remote Access PC).

- After the reception of a Remote Access message, the Supervision PC will

automatically call the island concerned, refreshing and thus reading all the

addresses concerned and then displaying them in the alarm list.

- The ‘Remote Access’ messages received are logged into the Routel logfile.

Screen Pop-Up after 3

Party PC Access

- A Remote PC Access Message as described above will in addition be displayed as

a Pop-Up message on screen.

Time-out for connection from PC (min.)

- This entry does not concern the Routel connections. It activates a time-out on a

Remote Access Connection (PC called 291).

- The time-out is armed at the moment of the connection (not after the last

keyboard/mouse activity).

- After the time-out, a message is displayed to warn the user that the connection will

be disconnected in 60 seconds. A button is available with this warning, which can

be used to re-arm the time-out if desired.

- A time-out value of 0 minutes disables the time-out feature.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications Omni 288S Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications Omni 288S