ZyXEL Communications Omni 288S Manual de usuario descargar pdf (Pagina 27)

novaPro32 Routel

Operation (technical)

7000991003 Q2

Sauter Systems

6 Operation (technical)

(This is not an ‘Operating Instructions’ manual for end users)

6.1 Start/stop of nP32

When stopping novaPro32 for the first time, the system will ask:-

Pressing ‘Yes’ will cause novaPro32 to stop without de-activating the Routel-addresses,

i.e. without calling the islands.

This means, in particular, that the islands will still report events by modem. The PC will

not take the phone. The ‘dial sequence’ (cf. Ch. 3.2) will determine the frequency of the

retries.

When starting novaPro32 following a ‘warm’ stop, the system will ask:-

Clicking ‘No’ will cause novaPro32 to start with a ‘cold’ start. This means all islands will

be called, the Routel (EP) addresses concerned will be re-activated in the AS and thus

be read.

Pressing ‘Yes’ will cause novaPro32 to start without re-activating the Routel addresses,

i.e. without calling the islands.

This means, in particular, that the data base of the current alarms on the PC is not

refreshed, which leads to no alarms being displayed in the alarm list thereafter.

Therefore, it's possible to make a cold start even after a warm stop. In any case, the

data base of the current alarms will be refreshed at the next following messaging of an

event from the island and the alarms of this island are then displayed in the alarm list

thereafter.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

ZyXEL Communications Omni 288S Manual de usuario Pagina 27