ZyXEL Communications VES-1012 - Guía de usuario descargar pdf (Pagina 139)

VES-1000 Series Ethernet Switch

SNMP Configuration 19-3

Table 19-2 SNMP Configuration Menu Fields

FIELD DESCRIPTION DEFAULT

Set Community Enter the set community, which is the password for incoming Set-

requests from the management station.

public

(default)

Trusted Host1-6 If you enter a trusted host, your VES will only respond to SNMP

messages from this address. If you leave the field set to 0.0.0.0

(default), your VES will respond to all SNMP messages it receives,

regardless of source.

0.0.0.0

(default)

Trap

Community Enter the trap community, which is the password sent with each trap to

the SNMP manager.

public

(default)

Destination1-2 Enter the IP address of the station to send your SNMP traps to. 0.0.0.0

(default)

Once you have completed filling in Menu 22 — SNMP Configuration, press [ENTER] at the message “Press

ENTER to Confirm…” to save your configuration, or press [ESC] to cancel.

19.4 SNMP Traps

The VES-1000 Series switch sends traps to an SNMP manager when an event occurs. SNMP traps supported are

outlined in the following table.

Table 19-3 SNMP Traps

GENERIC TRAP SPECIFIC TRAP DESCRIPTION

0 (Cold Start) 0 This trap is sent when the VES-1000 Series switch is

turned on.

1 (WarmStart) 0 This trap is sent when the VES-1000 Series switch

restarts.

2 (linkDown) 0 This trap is sent when the Ethernet or VDSL link is

down.

3 (linkUp) 0 This trap is sent when the Ethernet or VDSL link is up.

4 (authenticationFailure) 0 This trap is sent when an SNMP request comes from

non-authenticated hosts.

6 (enterpriseSpecific) 1(TRAP_REBOOT) This trap is sent when the system is going to reboot.

The trap displays the reason for the reboot.

2 (TRAP_SYSTEMSHUTDOWN) This trap is sent when the system is going to shut

down. The trap displays the reason for the shutdown.

3 (TRAP_OVERHEAT) This trap is sent when the temperature exceeds the

threshold of 65 degrees centigrade. For example, the

following trap shows that the current reading at Temp1

is 68 degrees centigrade.

"Temp1 exceeds Limit (Limit = 65 degree C, Read = 68

degree C)"

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 226 227

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications VES-1012 - Guía de usuario Pagina 139

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications VES-1012 -