ZyXEL Communications G-570U Guía de usuario descargar pdf (Pagina 87)

ZyXEL G-570U User’s Guide

Chapter 6 Wireless Screens 87

6.16 OTIST

In a wireless network, the wireless clients must have the same SSID and security settings as

the access point (AP) or wireless router (we will refer to both as “AP” here) in order to

associate with it. Traditionally this meant that you had to configure the settings on the AP and

then manually configure the exact same settings on each wireless client.

OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP’s SSID

and WEP or WPA-PSK security settings to wireless clients that support OTIST and are within

transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if

you didn’t configure one manually.

Note: OTIST replaces the pre-configured wireless settings on the wireless clients.

6.16.1 Enabling OTIST: G-570U in AP Mode

You must enable OTIST on both the AP and wireless client before you start transferring

settings.

Note: The AP and wireless client(s) MUST use the same Setup key.

6.16.1.1 AP

You can enable OTIST using the OTIST button or the web configurator.

6.16.1.1.1 AP Mode: OTIST Button

If you use the OTIST button, the default (01234567) or previous saved (through the web

configurator) Setup key is used to encrypt the settings that you want to transfer.

Hold in the OTIST button for one or two seconds to activate OTIST.

6.16.1.1.2 AP Mode: Web Configurator

Click Wireless > OTIST to configure and enable OTIST. The screen appears as shown.

Note: At the time of writing the device does not support OTIST in Bridge or

AP+Repeater mode.

Figure 53 AP Mode: OTIST

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 161 162

Sin comentarios

ZyXEL Communications G-570U Guía de usuario Pagina 87