ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Guía de usuario descargar pdf (Pagina 75)

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

6.7.2 WLAN Interface Commands

Use these commands to configure global settings that apply to all of the wireless LAN

interfaces you create on the WLAN card.

Table 31 WLAN Interface Commands

COMMAND DESCRIPTION

[no] interface ap_interface Creates the specified interface if necessary and enters sub-

command mode. The

no command deletes the specified

interface.

ap_interface: The name of the WLAN Access Point

interface. Use wlan-x-y where x equals the number of the

card slot and y equals the number of the individual WLAN

interface. For example, wlan-1-1.

[no] block-intra Enables intra-BSS blocking (prevents) wireless clients in this

profile’s BSS from communicating with one another.

group-key <30..30000> Sets the WPA2 group key update timer. This is the interval in

seconds for how often the AP sends a new group key out to

all clients.

[no] hide Obscures the SSID in the outgoing beacon frame so a station

cannot obtain the SSID through scanning.

idle <30..30000> Sets the WPA2 idle timeout. The ZyWALL automatically

disconnects a wireless station that has been inactive for this

number of seconds. The wireless station needs to enter the

username and password again before access to the wired

network is allowed.

[no] ip address ip subnet_mask Assigns the specified IP address and subnet mask to the

specified interface. The

no command clears the IP address

and the subnet mask.

[no]ip gateway ip [metric <0..15>] Adds the specified gateway for the interface. Sets the priority

(relative to every gateway on every interface) for the specified

gateway. The lower the number, the higher the priority. The

no command removes the gateway.

[no] mtu <576..2304> Specifies the Maximum Transmission Unit, which is the

maximum number of bytes in each packet moving through

this interface. The ZyWALL divides larger packets into smaller

fragments. The

no command resets the MTU to 1500.

reauth <30..30000> Sets the WPA2 reauthentication timer. This is at what interval

wireless stations have to resend usernames and passwords

in order to stay connected. If a RADIUS server authenticates

wireless stations, the reauthentication timer on the RADIUS

server has priority.

security mode {none | wep | wpa |

wpa-wpa2 | wpa2}

Sets what type of security the wireless interface uses.

none: applies no security.

wep: WEP security (extremely weak).

wpa: WPA security.

wpa-wpa2: WPA/WPA2-Enterprise or WPA/WPA2-PSK

security.

wpa2: WPA2 security (strongest option).

security wep <64 | 128> default-key

<1..4>

Sets WEP encryption to use a 64 or 128 bit key and selects

the default key.

security wep mode <open | share> Sets the WEP encryption to use open or shared key

authentication.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 385 386

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Guía de usuario Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1