
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
81
6.10.1 Auxiliary Interface Command Examples
The following commands show you how to set up the auxiliary interface aux with the
following parameters: phone-number 0340508888, tone dialing, port speed 115200, initial-
string ATZ, timeout 10 seconds, retry count 2, retry interval 100 seconds, username kk,
password kk@u2online, chap-pap authentication, and description “I am aux interface”.
The following commands show how to dial, disconnect, and stop the auxiliary interface.
[no] phone-number phone Specifies the phone number of the auxiliary
interface. You can use 1-20 numbers, commas (,),
or plus signs (+). Use a comma to pause during
dialing. Use a plus sign to tell the external modem
to make an international call. The
no command
clears the phone number.
[no] port-speed {9600 | 19200 | 38400 |
57600 | 115200}
Specifies the baud rate of the auxiliary interface.
The
no command sets the baud rate to 115200.
[no] username username Specifies the username of the auxiliary interface.
The no command clears the username.
username: You can use alphanumeric,
underscores (_), dashes (-), and
/@$ characters,
and it can be up to 30 characters long.
Table 37 interface Commands: Auxiliary Interface (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# interface aux
Router(config-if-aux)# phone-number 0340508888
Router(config-if-aux)# dialing-type tone
Router(config-if-aux)# port-speed 115200
Router(config-if-aux)# initial-string ATZ
Router(config-if-aux)# timeout 10
Router(config-if-aux)# retry-count 2
Router(config-if-aux)# retry-interval 100
Router(config-if-aux)# username kk
Router(config-if-aux)# password kk@u2online
Router(config-if-aux)# authentication chap-pap
Router(config-if-aux)# description I am aux interface
Router(config-if-aux)# exit
Router# interface dial aux
Router# interface disconnect aux
Comentarios a estos manuales