ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Guía de usuario descargar pdf (Pagina 95)

100

101

Chapter 8 Route

ZyWALL (ZLD) CLI Reference Guide

Figure 15 Example of Static Routing Topology

8.4 Static Route Commands

The following table describes the commands available for static route. You must use the

configure terminal command to enter the configuration mode before you can use these

commands.

8.4.1 Static Route Commands Example

The following command sets a static route with IP address 10.10.10.0 and subnet mask

255.255.255.0 and with the next-hop interface ge1. Then use the show command to display

the setting.

Table 44 Command Summary: Static Route

COMMAND DESCRIPTION

[no] ip route {w.x.y.z} {w.x.y.z}

{interface|w.x.y.z} <0..127>

Sets a static route. The no command disables a

static route.

ip route replace {w.x.y.z} {w.x.y.z}

{interface|w.x.y.z} <0..127> with {w.x.y.z}

{w.x.y.z} {interface|w.x.y.z} <0..127>

Changes an existing route’s settings.

show ip route-settings Displays static route information. Use show ip

route to see learned route information. See

Section 9.2.5 on page 100.

Router(config)# ip route 10.10.10.0 255.255.255.0 ge1

Router(config)#

Router(config)# show ip route-settings

Route Netmask Nexthop Metric

===========================================================================

10.10.10.0 255.255.255.0 ge1 0

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 385 386

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Guía de usuario Pagina 95

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1