ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Guía de usuario Pagina 78

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 386
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 77
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
78
6.7.3.1 WLAN MAC Filter Commands Example
This example creates a MAC filter entry for MAC address 01:02:03:04:05:06 and sets the
ZyWALL to allow wireless access from that entry’s MAC address only.
6.8 VLAN Interface Specific Commands
This section covers commands that are specific to VLAN interfaces. VLAN interfaces also use
many of the general interface commands discussed at the beginning of Section 6.2 on page 51.
The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
This table lists the VLAN interface commands.
Router(config)# wlan mac-filter 01:02:03:04:05:06 description example
Router(config)# wlan mac-filter associate allow
Router(config)# wlan mac-filter activate
Router(config)# show wlan mac-filter status
Enable: yes
Association: allow
Router(config)# show wlan mac-filter
No. MAC Description
===========================================================================
1 01:02:03:04:05:06 example
Table 33 Input Values for VLAN Interface Commands
LABEL DESCRIPTION
interface_name VLAN interface: vlanx, x = 0 - 4094
Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 -
N, where N equals the highest numbered Ethernet interface for your
ZyWALL model.
The ZyWALL USG 100 and 200 models use a name such as wan1,
wan2, opt, lan1, ext-wlan, or dmz.
Table 34 interface Commands: VLAN Interfaces
COMMAND DESCRIPTION
interface interface_name Creates the specified interface if necessary and
enters sub-command mode.
[no] port interface_name Specifies the Ethernet interface on which the VLAN
interface runs. The
no command clears the port.
[no] vlan-id <1..4094> Specifies the VLAN ID used to identify the VLAN.
The
no command clears the VLAN ID.
show port vlanid Displays the Ethernet interface VLAN settings.
Vista de pagina 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 385 386

Comentarios a estos manuales

Sin comentarios