ZyXEL Communications PLA-400 V2 - V3.0.5 Guía de usuario descargar pdf (Pagina 305)

ZyAIR Wireless Gateway Series User’s Guide

Firmware and Configuration File Maintenance 28-3

28.2.1 Backup Configuration

Follow the instructions as shown in the next screen.

Figure 28-1 Telnet in Menu 24.5

28.2.2 Using the FTP Command from the Command Line

Step 1. Launch the FTP client on your computer.

Step 2. Enter “open”, followed by a space and the IP address of your ZyAIR.

Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter your password as requested (the default is “1234”).

Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Use “get” to transfer files from the ZyAIR to the computer, for example, “get rom-0 config.rom”

transfers the configuration file on the ZyAIR to your computer and renames it “config.rom”. See

earlier in this chapter for more information on filename conventions.

Step 7. Enter “quit” to exit the ftp prompt.

Menu 24.5 - Backup Configuration

To transfer the configuration file to your workstation, follow the procedure

below:

1. Launch the FTP client on your workstation.

2. Type "open" and the IP address of your router. Then type "root" and

SMT password as requested.

3. Locate the 'rom-0' file.

4. Type 'get rom-0' to back up the current router configuration to

your workstation.

For details on FTP commands, please consult the documentation of your FTP

client program. For details on backup using TFTP (note that you must remain

in this menu to back up using TFTP), please see your router manual.

Press ENTER to Exit:

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 395 396

Sin comentarios

ZyXEL Communications PLA-400 V2 - V3.0.5 Guía de usuario Pagina 305