ZyXEL Communications GS3700 Series Guía de usuario descargar pdf (Pagina 159)

Chapter 16 Port Authentication

GS3700/XGS3700 Series User’s Guide

159

The following table describes the labels in this screen.

Table 66 Advanced Application > Port Authentication > MAC Authentication

LABEL DESCRIPTION

Active Select this check box to permit MAC authentication on the Switch.

Note: You must first enable MAC authentication on the Switch before configuring it on each

port.

Name Prefix Type the prefix that is appended to all MAC addresses sent to the RADIUS server for

authentication. You can enter up to 32 printable ASCII characters.

If you leave this field blank, then only the MAC address of the client is forwarded to the

RADIUS server.

Password Type the password the Switch sends along with the MAC address of a client for

authentication with the RADIUS server. You can enter up to 32 printable ASCII characters.

Timeout Specify the amount of time before the Switch allows a client MAC address that fails

authentication to try and authenticate again. Maximum time is 3000 seconds.

When a client fails MAC authentication, its MAC address is learned by the MAC address

table with a status of denied. The timeout period you specify here is the time the MAC

address entry stays in the MAC address table until it is cleared. If you specify 0 for the

timeout value, then this entry will not be deleted from the MAC address table.

Note: If the Aging Time in the Switch Setup screen is set to a lower value, then it

supersedes this setting. See Section 6.4 on page 60.

Port This field displays a port number.

* Use this row to make the setting the same for all ports. Use this row first and then make

adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Active Select this check box to permit MAC authentication on this port. You must first allow MAC

authentication on the Switch before configuring it on each port.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel

to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 415 416

Sin comentarios

ZyXEL Communications GS3700 Series Guía de usuario Pagina 159