ZyXEL Communications GS3700 Series Guía de usuario Pagina 240

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 416
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 239
Chapter 24 IP Source Guard
GS3700/XGS3700 Series User’s Guide
240
24.7 ARP Inspection Configure
Use this screen to enable ARP inspection on the Switch. You can also configure the length of time
the Switch stores records of discarded ARP packets and global settings for the ARP inspection log.
To open this screen, click Advanced Application > IP Source Guard > ARP Inspection >
Configure.
Figure 144 IP Source Guard > ARP Inspection Configure
The following table describes the labels in this screen.
Table 114 IP Source Guard > ARP Inspection Configure
LABEL DESCRIPTION
Active Select this to enable ARP inspection on the Switch. You still have to enable ARP
inspection on specific VLAN and specify trusted ports.
Filter Aging Time
Filter aging time This setting has no effect on existing MAC address filters.
Enter how long (1-2147483647 seconds) the MAC address filter remains in the Switch
after the Switch identifies an unauthorized ARP packet. The Switch automatically deletes
the MAC address filter afterwards. Type 0 if you want the MAC address filter to be
permanent.
Log Profile
Log buffer size Enter the maximum number (1-1024) of log messages that were generated by ARP
packets and have not been sent to the syslog server yet. Make sure this number is
appropriate for the specified Syslog rate and Log interval.
If the number of log messages in the Switch exceeds this number, the Switch stops
recording log messages and simply starts counting the number of entries that were
dropped due to unavailable buffer. Click Clearing log status table in the ARP
Inspection Log Status screen to clear the log and reset this counter. See Section
24.6.2 on page 239.
Vista de pagina 239
1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 415 416

Comentarios a estos manuales

Sin comentarios