ZyXEL Communications GS3700 Series Guía de usuario Pagina 346

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 416
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 345
Chapter 42 Access Control
GS3700/XGS3700 Series User’s Guide
346
42.3.7 Configuring SNMP User
From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 230 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Active Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Apply Click Apply to save your changes to the Switchs run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 179 Management > Access Control > SNMP > Trap Group > Port (continued)
LABEL DESCRIPTION
Table 180 Management > Access Control > SNMP > User
LABEL DESCRIPTION
User Information
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Username Specify the username of a login account on the Switch.
Vista de pagina 345
1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 415 416

Comentarios a estos manuales

Sin comentarios