ZyXEL Communications GS3700 Series Guía de usuario descargar pdf (Pagina 359)

100

101

Chapter 42 Access Control

GS3700/XGS3700 Series User’s Guide

359

You can specify a group of one or more “trusted computers” from which an administrator may use a

service to manage the Switch. Click Access Control to return to the Access Control screen.

Figure 243 Management > Access Control > Remote Management

The following table describes the labels in this screen.

Table 183 Management > Access Control > Remote Management

LABEL DESCRIPTION

Entry This is the client set index number. A “client set” is a group of one or more “trusted

computers” from which an administrator may use a service to manage the Switch.

Active Select this check box to activate this secured client set. Clear the check box if you wish to

temporarily disable the set without deleting it.

Start Address

End Address

Configure the IP address range of trusted computers from which you can manage this

Switch.

The Switch checks if the client IP address of a computer requesting a service or protocol

matches the range set here. The Switch immediately disconnects the session if it does not

match.

Telnet/FTP/

HTTP/ICMP/

SNMP/SSH/

HTTPS

Select services that may be used for managing the Switch from the specified trusted

computers.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel

to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 415 416

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications GS3700 Series Guía de usuario Pagina 359

Comentarios a estos manuales