ZyXEL Communications GS3700 Series Guía de usuario descargar pdf (Pagina 70)

Chapter 6 Basic Setting

GS3700/XGS3700 Series User’s Guide

Note: If the priority settings for two or more PoE ports are the same and the power

budget is not enough, the ports will shut down randomly. We strongly recommend

you set the priority for each PoE port to make sure the high priority ports get power.

Note: In classification mode, up to five ports can be active. (The Switch reserves 36W per

port and the total power budget is 180W). Select consumption mode if you want

more ports to be active.

6.8 Interface Setup

An IPv6 address is configured on a per-interface basis. The interface can be a physical interface (for

example, an Ethernet port) or a virtual interface (for example, a VLAN). The Switch supports the

VLAN interface type for IPv6 at the time of writing.

PD Priority This field is not available for the SFP or SFP+ ports.

When the total power requested by the PDs exceeds the total PoE power budget on the

Switch, you can set the PD priority to allow the Switch to provide power to ports with

higher priority.

Select Critical to give the PD connected to this port the highest priority.

Select High to set the Switch to assign the remaining power to the port after all critical

priority ports are served.

Select Low to set the Switch to assign the remaining power to the port after all critical

and high priority ports are served.

Max Power (mW) Set the maximum amount of power (from 1000 to 33000) the PD could use from the

Switch on this port. Otherwise, leave the field blank to allow the connected PD to use

power up to the Switch’s total power budget.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the nonvolatile memory when you are done

configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Table 14 Basic Setting > PoE Status > PoE Setup

LABEL DESCRIPTION

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 415 416

Sin comentarios

ZyXEL Communications GS3700 Series Guía de usuario Pagina 70