ZyXEL Communications IES-708 Guía de usuario descargar pdf (Pagina 211)

Chapter 32 ACL

IES-708-22A User’s Guide

211

Figure 106 Advanced Application > ACL

The following table describes the labels in this screen.

Table 69 Advanced Application > ACL

LABEL DESCRIPTION

ACL Profile Setup Click ACL Profile Setup to open the screen where you can set up ACL profiles

(see Section 32.3 on page 212).

ACL Profile Map Click ACL Profile Map to open the screen where you can look at which ACL

profiles are assigned to which PVCs (see Section 32.4 on page 213).

Port Use this drop-down list box to select a port to which you wish to assign an ACL

profile. This field is read-only once you click on a port number below.

VPI Type the Virtual Path Identifier for a channel on this port.

VCI Type the Virtual Circuit Identifier for a channel on this port.

ACL Profile Use the drop-down list box to select the ACL profile you want to assign to this

PVC.

Apply Click this to save your changes to the IES-708-22A’s volatile memory. The IES-

708-22A loses these changes if it is turned off or loses power, so use the Config

Save link on the navigation panel to save your changes to the non-volatile

memory when you are done configuring.

Cancel Click Cancel to start configuring the screen again.

Show Port Select which DSL port(s) for which to display ACL profile settings.

Index This field displays the number of the PVC. Click a PVC’s index number to use

the top of the screen to edit the PVC.

Note: At the time of writing, you cannot edit the VPI and VCI. If

you want to change them, add a new PVC with the desired

settings. Then you can delete any unwanted PVCs.

Port This field displays the number of the DSL port on which the PVC is configured.

VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier

(VCI). The VPI and VCI identify a channel on this port.

ACL Profile This field shows the ACL profile assigned to this PVC.

Select

Delete

Select the check box in the Select column for an entry, and click Delete to

remove the entry.

Select All Click this to select all entries in the table.

Select None Click this to un-select all entries in the table.

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 447 448

Sin comentarios

ZyXEL Communications IES-708 Guía de usuario Pagina 211