ZyXEL Communications IES-708 Guía de usuario descargar pdf (Pagina 315)

100

101

IES-708-22A User’s Guide

315

CHAPTER 50

IP Commands

This chapter shows you how to use the (standard shell) IP commands to configure the IP

(Internet Protocol) parameters.

50.1 IP Commands Introduction

Use the IES-708-22A’s management IP addresses to manage it through the network.

50.2 IP Settings and Default Gateway

Use the following command sequence to set the IES-708-22A’s IP settings for the Ethernet 1

and 2, and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports,

you must connect to the IES-708-22A through a port that is a member of the management

(CPU) VLAN in order to perform in-band management.

where

The first command changes the IP settings for the IES-708-22A’s uplink, downlink and IES-

708-22A DSL ports. If you don’t enter the subnet mask, the system automatically computes

the subnet mask.

ras> ip set <ip>[/<netmask>]

ras> ip gateway <gateway ip>

ras> config save

<ip> =

The IP address you want to configure for the IES-708-22A.

<netmask> =

The bit number of the subnet mask of the IP address you want to

configure for IES-708-22A’s uplink, downlink and IES-708-

22A DSL ports. To find the bit number, convert the subnet mask

to binary and add all of the 1’s together. Take “255.255.255.0”

for example. 255 converts to eight 1’s in binary. There are three

255’s, so add three eights together and you get the bit number

(24).

<gateway ip> =

The default gateway IP address you want to configure for the

IES-708-22A.

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 447 448

Comentarios a estos manuales

Sin comentarios

ZyXEL Communications IES-708 Guía de usuario Pagina 315

Comentarios a estos manuales

Relacionado con productos y manuales para Redes ZyXEL Communications IES-708